How To Disassemble Remington 700 Bolt?

The Remington 700 bolt is one of the most widely used bolt action rifles in the world. It is reliable, accurate, and easy to use, making it a popular choice for hunters and target shooters alike. However, it is important to understand how to disassemble the Remington 700 bolt in order to properly maintain and repair your rifle. Here is a step-by-step guide on how to disassemble a Remington 700 bolt.

Details About  Disassemble Remington 700 Bolt

The Remington 700 Bolt is one of the most popular and reliable bolt action rifles on the market today. It is a relatively simple design, with only a few parts that need to be disassembled for cleaning or repair.

  • To remove the bolt from the gun, first, make sure the rifle is unloaded and the safety is on. Pull the bolt to the rear and rotate the bolt handle. This will release the bolt from the receiver.
  • Next, you will need to remove the firing pin. To do this, use a punch and hammer to drive the firing pin out of the bolt. Be sure to note the orientation of the firing pin, as it will need to be re-installed the same way.
  • Once the firing pin is removed, the extractor can be taken off. The extractor is held in place by a small pin. Use a punch and hammer to drive the pin out and then carefully remove the extractor.
  • The bolt head can then be removed by unscrewing the two screws that hold it in place. As you unscrew the screws, note the orientation of the bolt head, as it will need to be re-installed the same way.
  • Finally, the bolt can be separated from the bolt body. Use a punch and hammer to drive the pin out of the bolt body and then carefully separate the two pieces.

After disassembling the bolt, you have to clean and lubricate all the parts before re-assembly. You can follow the manufacturer’s instructions for proper cleaning and lubrication. Once all the parts have been cleaned and lubricated, re-assemble the bolt in the reverse order of disassembly.

Expert Tips for Disassembly & Reassembly

  1. Always use caution when disassembling and reassembling components. Make sure to pay attention to the order in which you remove each component, as this will help ensure that you reassemble it correctly.
  2. Before beginning the process, gather the necessary tools and make sure that they are working properly.
  3. Take photos or draw diagrams of the component before and after disassembly. This will help you remember how the components fit together and make reassembly quicker and easier.
  4. If possible, use a parts tray to keep small components organized and prevent them from getting lost.
  5. Label and store each component separately, so that you know exactly where each piece goes when it’s time to reassemble the component.
  6. Pay attention to the instructions and diagrams provided in the manual. This will help you keep track of the order in which each component should be inserted or removed.
  7. If possible, use antistatic bags to store components when not in use, as this will help protect them from damage.
  8. Take your time and be patient. Disassembly and reassembly can be tricky, so it’s important to be methodical so that you don’t miss any steps.

Don’t Be Intimidated: Disassembling a Rem 700 Bolt Is Easy

Yes, disassembling a Rem/Remington 700 bolt is fairly easy and not intimidating at all. The process is straightforward, and with a few basic tools, anyone can do it. But you need to pay attention to the order in which the bolt parts are removed, as well as any safety precautions that may be needed when dealing with firearms.

Final Word

As you see the process of disassembling a Rem/Remington 700 bolt is not a hard-nut job but simple and straightforward. Just you need to take the necessary safety precautions and be careful when handling the parts involved. With the right tools and some patience, anyone can take apart and reassemble their Remington 700 bolt with ease.